INSTRUCTION MANUAL R BUILT-IN WINE COOLER MODEL: KMWC408 E-mail: Support@tittla.com Phone: 1(510)228-4672 Read this manual and follow all safety rules and operating instructions before first use of this wine cooler.
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS 3 PRODUCT DIAGRAM 5 INSTALLATION INSTRUCTIONS 6 Before Using Your Wine Cooler 6 To Install Stainless Steel Handle 6 To Install Your Wine Cooler 7 OPERATION INSTRUCTIONS 9 Controls 9 Recommended Temperature Settings 10 Storage 10 Shelves 11 CARE & MAINTENANCE 11 Cleaning Your Wine Cooler 11 Power Failure 12 Vacation Time 12 Moving Your Wine Cooler 12 Energy Saving Tips 12 Charcoal Filtration System 13 TROUBLESHOOTING GUIDE
IMPORTANT SAFETY INSTRUCTIONS Your safety and the safety of others are very important. This wine cooler complies with the applicable safety requirements and is safe for daily use. However, basic safety precautions should always be followed when using an electrical appliance, to reduce the risk of fire, electric shock, and personal injury. Plug into its own individual electrical outlet with a voltage rating that matches the rating label on the cooler (115/120V AC only, 60Hz, 10A).
Do not use this wine cooler for other than its intended purpose. For indoor, household use only. Move this wine cooler by 2 people. Failure to do so can result in injury. Place this wine cooler in a well-ventilated area with temperatures above 15°C (60°F) and below 32°C (90°F). To ensure proper ventilation for your wine cooler, the front of the cooler must be completely unobstructed. This wine cooler must be installed in an area away from wind, rain, water spray or drips.
PRODUCT DIAGRAM 1 Control Panel 4 Leveling Legs 2 Shelves 5 Top Hinge 3 Exhaust Window 6 Glass Door with Handle 5
INSTALLATION INSTRUCTIONS Before Using Your Wine Cooler - Remove the exterior and interior packaging. - Check to be sure you have all of the following parts: o 14 Shelves o Stainless Steel Handle o Instruction Manual o 2 Extra Screws for Installing Handle - IMPORTANT: Before connecting this wine cooler to a power source, let it stand upright for approximately 24 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
Illustration #1 Illustration #2 1 Gasket 2 Screw 3 Screw Driver 4 Handle To Install Your Wine Cooler This wine cooler is designed for free standing or built-in (fully recessed) installation. Place your wine cooler on a solid and level floor that is strong enough to support it when it is fully loaded. This will ensure a vibration-free and noise-free operation. Adjust the leveling legs in and out to stabilize the cooler horizontally.
fluctuate, and the temperature range of 5ºC-18ºC (40ºF-65ºF) may not be reached. Connect the wine cooler to an exclusive, properly grounded, standard electrical supply (115 V AC only, 60 Hz), in accordance with the National Electrical Code and local codes and ordinances. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized products service center. Warning: Improper use of the grounded plug can result in the risk of electrical shock.
OPERATION INSTRUCTIONS Controls After plugging the wine cooler into a wall outlet, the cooler would turn on automatically and the LCD screen would show the temperature inside of the cooler. After setting your desired serving temperature, allow the cooler to cool down for 3 to 4 hours before placing wine bottles in the wine cooler. °C °F Press once to turn the interior light ON or OFF.
Light Control The light will automatical turns off 10 mins later for energy saving. Note: To keep the light staying on always, please press the lighting mark until you hear 2 “beep” Recommended Temperature Settings Storing wines at the proper temperature is important. To preserve them as long as possible, wine needs to be stored at approximately 55° Fahrenheit. However, the chart below suggests the optimal drinking temperature for the different varietal of wine.
Shelves To remove the shelves from the track, pull each shelf out to the shelf post,as shown infigure A. Lift it up again, then slowly pull the shelf out, as shown in figure B. Figure A Figure B CARE & MAINTENANCE Cleaning Your Wine Cooler IMPORTANT: Always unplug the cooler before cleaning or performing maintenance. Never use harsh cleansers or scouring pads to clean any part of the cooler. . Turn off the power, unplug the wine cooler, and remove all items including shelves. .
Power failure Most power failures are corrected within a few hours and should not affect the temperature of your wine cooler. If the power is off for an extended period of time, proper steps should be taken to protect your contents. Vacation Time Leave the wine cooler operating during vacations of less than three weeks. For periods longer than this, turn the wine cooler off and leave the door slightly ajar to prevent odor from building inside the wine cooler.
Charcoal filtration system Your wine is a living object that breathes through the cork of its bottle. In order to preserve the quality and taste of your fine wines, they must be stored at the ideal temperature and ambient conditions. Your wine cooler is equipped with an active charcoal filtration system to ensure air purity, cooling efficiency, and to maintain an odor free cabinet for the storage of your fine wines.
TROUBLESHOOTING GUIDE PROBLEM The wine cooler does not run. The wine cooler is not cold enough. The compressor turns on and off frequently. POSSIBLE CAUSE SOLUTION The wine cooler may not be plugged in, or plug may be loose. Ensure the wine cooler has been plugged in properly. The wine cooler is turned off. Press to turn on the cooler. House fuse blown or tripped circuit breaker. Check/replace fuse. Reset circuit breaker. External environment may require a higher setting. Set a colder setting.
PROBLEM The light does not work. POSSIBLE CAUSE SOLUTION Not plugged in. Plug the cooler in. The circuit breaker tripped or a blown fuse. Check the breaker and/or fuses. The light button is “OFF”. Vibrations. The cooler seems to make too much noise. The door will not close properly. Moisture build up on interior or exterior of the wine cooler. Error Code: E1-E2-E3-E4-E7-E8 Press to turn the light ON. The cooler is not leveled. Check to assure that the cooler is level.
Warranty Terms Warranty Period 1. Customers are entitled to replacement or free repair service in case of quality defect(s) found in the product within 15 days upon receipt of the product. 2. Customers are entitled to free repair service from TITTLA for any product proven defective in material or workmanship that results in product failure during normal consumer usage and conditions within the valid warranty period, which is 12 months counting from the date of selling.