Specification

Titebond Molding & Trim Glue
Exposure controls/personal protection8 .
Use a properly fitted, air-purifying or air-fed respirator complying with an approved
standard if a risk assessment indicates this is necessary. Respirator selection must be
based on known or anticipated exposure levels, the hazards of the product and the safe
working limits of the selected respirator.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists or
dusts.
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before handling
this product.
Personal protection
Eyes
Skin
Respiratory
:
:
:
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary.
Hands :
Hygiene measures : Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period. Appropriate
techniques should be used to remove potentially contaminated clothing. Wash
contaminated clothing before reusing. Ensure that eyewash stations and safety showers
are close to the workstation location.
Environmental exposure
controls
: Emissions from ventilation or work process equipment should be checked to ensure they
comply with the requirements of environmental protection legislation.
100°C (212°F)
Liquid.
40% (w/w)
4.8
1.1
Soluble in the following materials: cold water and hot water.
Faint odor.
Beige. [Light]
Boiling/condensation point
Physical and chemical properties
Physical state
pH
Relative density
Volatility
Solubility
Odor
Color
9.8 g/lVOC (less water, less
exempt solvents)
:
:
:
:
:
:
:
:
:
Flash point : Closed cup: >93.3°C (>199.9°F) [Setaflash.]
9 .
The product is stable.
No specific data.
Under normal conditions of storage and use, hazardous polymerization will not occur.
Under normal conditions of storage and use, hazardous decomposition products should
not be produced.
No specific data.
Stability and reactivity
Chemical stability
Conditions to avoid
Materials to avoid
Hazardous decomposition
products
Hazardous polymerization
:
:
:
:
:
10 .
Possibility of hazardous
reactions
: Under normal conditions of storage and use, hazardous reactions will not occur.
Reactive or incompatible with the following materials: alkalis and moisture.:Incompatibility
4/924031/27/2010.