Owner's manual

Page 8 @)1&/2:(+.:4=&A02'/.)+'B&6=24'2&:4==&CD###DE#$D$EC#, Item 64804 64805
FG@<HI JGKLH<LGLM<NGFKM&O<PQKLR O<PQKLR&HKSFF<HTS
1. H01+&/(2&S)*21&F*./:(&V@@&4+>&0+6=09&
/(2&O2=>21&328)12&61):22>.+9,
2. Pull up on the Door Latch,
then open the Door.
3. b&S)0+>&O.12&F6))=&K+'/4==4/.)+5
Remove the Wingnut, Keyed Washers, and
Spring. If replacing a Spool, remove the old
Spool and all remaining wire from the liners.
4. Place the new Wire Spool over the Spool Spindle
and against the Spool Brake Pad as illustrated.
H)&612X2+/&*.12&822>&61)3=2;'B&'2/&/(2&F6))=&
')&/(4/&./&*.==&0+*.+>&:)0+/21:=):\*.'2,
5. Line up the Keyed Washers with
the groove on the Spindle. Replace
the Keyed Washers and Spring
over the Spool Spindle and secure
Spool in place with the Wingnut.
L)/.:25 If Wire Spool can spin freely, Wingnut is too
loose. This will cause the welding wire to unravel and
unspool which can cause tangling and feeding problems.
S)*21&
F*./:(
Q))1&
P4/:(
Q))1
O2=>21&
O4==
O.+9+0/
b&=3&&
O.12&F6))=
F6))=&
N14\2&S4>
Y2W2>&
O4'(21
Y2W2>&
O4'(21
F61.+9
F6))=&
F6.+>=2
b&=3&F6))=&P)4>.+9
F2/06
U24>&/(2&<LHKU<&KJSVUHGLH&FG@<HI&KL@VUJGHKVL&'2:/.)+&4/&/(2&329.++.+9&)8&/(.'&;4+04=&
.+:=0>.+9&4==&/2[/&0+>21&'03(24>.+9'&/(212.+&328)12&'2/&06&)1&0'2&)8&/(.'&61)>0:/,
HV&SU<-<LH&F<UKVTF&KLcTUI&@UVJ&GMMKQ<LHGP&VS<UGHKVL5&
H01+&/(2&S)*21&F*./:(&)88&4+>&0+6=09&/(2&O2=>21&328)12&'2/06,
L)/25&Remove the protective foam and cardboard from the Welder before setup.
Wire Spool Installation / Wire Setup