Owner's manual

Page 21@)1&/2:(+.:4=&A02'/.)+'B&6=24'2&:4==&CD###DE#$D$EC#,Item 64804 64805
FG@<HIJGKLH<LGLM< NGFKM&O<PQKLRO<PQKLR&HKSF F<HTS
1. Press (and hold) Trigger and contact the area
to be welded with electrode wire to ignite arc.
2. For a narrow weld, you can usually draw the wire in
a steady straight line.
This is called a stringer bead.
For a wider weld, draw the wire back and forth
across the joint.
This is called a weave bead and takes
practice to perform properly.
3. Direct the welding wire straight into the joint. This
gives an angle of 90° (straight up and down)
for butt (end to end) welds, and an angle
of 45° for fillet (T-shaped) welds.
4. For MIG welding using solid wire and
shielding gas, the end of the MIG Gun
should be tilted so that wire is angled
anywhere in-between straight on and
15° away from the direction you are welding.
The amount of tilt is called the push angle.
5. When using flux-cored wire without
shielding gas, the end of the MIG Gun
should be tilted so that wire is angled
anywhere in-between straight on and
15° in the direction you are welding.
The amount of tilt is called the drag angle.
6. The Contact Tip should remain within 1/2″
of the work surface. This distance is called
CTWD - Contact Tip to Work Distance.
'/1.+921&324> *24X2&324>
O2=>&JKR&R0+&4+9=2'B&&
X.2*2>&81);&81)+/&)8&*2=>&^).+/,
"%k
8.==2/&*2=>&^).+/
90°
30//&*2=>&^).+/
MHOQ&&
(up to 1/2")
O2=>&
Q.12:/.)+
S0'(&G+9=2
$DC%k
O2=>&
Q.12:/.)+
Q149&G+9=2
$DC%k
F)=.>&O.12&*./(&F(.2=>.+9&R4' @=0[DM)12>&O.12&*./()0/&R4'
N4'.:&O2=>.+9&H2:(+.A02