Owner's manual

Page 17@)1&/2:(+.:4=&A02'/.)+'B&6=24'2&:4==&CD###DE#$D$EC#,Item 64804 64805
FG@<HIJGKLH<LGLM< NGFKM&O<PQKLRO<PQKLR&HKSF F<HTS
K+/21.)1&M)+/1)='
K>=21&
G1;
O.12&@22>&
J2:(4+.';
O.12&F6))=
F6))=&Y+)3
@22>&
H2+'.)+21
O.12&K+=2/&
P.+21
@22>&&
U)==21&
Y+)3
JKR&@=0[&
/ Spool Gun
F*./:(
R4'&d0.:\&
M)++2:/)1
L)/25 When using an optional Spool Gun (sold separately), disconnect the Wire Feed Gas Hose from the
Gas Quick Connector, thread the gas hose from the Spool Gun through the round hole in the front of the Welder and
connect it to the Gas Quick Connector, and place the MIG Flux/Spool Gun Switch on the Spool Gun setting.
For all other welding, place the MIG Flux/Spool Gun Switch on the MIG Flux Gun setting
and connect the Wire Feed Gas Hose to the Gas Quick Connector. The collar on the
Gas Quick Connector must click into place after attaching any hose to it.
O2=>&F2//.+9'
Refer to the Settings Chart on the inside of the Welder door for Flux-Cored and MIG Weld settings.
The chart is only intended to show general guidelines for different wire sizes and for different
thicknesses of material. The initial settings used at the beginning of a weld may need to be
adjusted after stopping and carefully inspecting the weld. Proper welding takes experience.