Owner's manual

Page 12 @)1&/2:(+.:4=&A02'/.)+'B&6=24'2&:4==&CD###DE#$D$EC#, Item 64804 64805
FG@<HI JGKLH<LGLM<NGFKM&O<PQKLR O<PQKLR&HKSFF<HTS
15. Loosen the Knob on the Wire Feed
mechanism, then insert the Gun Cable
Connector through the hole on the Welder
front and into the socket on the Wire Feed.
16. Ensure that the Gun Cable Connector is fully
inserted into the socket on the Wire Feed
mechanism as shown.
L)&VD1.+9&'()0=>&32&X.'.3=2,
Tighten the Knob securely.
If Connector is not fully inserted, the gas
connection will leak, preventing shielding
gas from reaching the welding arc.
LVHKM<5 To prevent damage,
do not overtighten the Knob.
17. Connect the Wire Feed Control Cable to the
Wire Feed Control Socket located on the front
of the machine. Press it in until the collar snaps
into place. Note that the plug on the Cable fits
into the Socket in one specific orientation only.
To disconnect it, pull the collar back first.
KJSVUHGLH
F2:012=W&()=>&)+/)&/(2&2+>&)8&/(2&*2=>.+9&*.12&4+>&\226&
/2+'.)+&)+&./&>01.+9&/(2&8)==)*.+9&'/26',
K8&/(.'&.'&+)/&>)+2B&/(2&*2=>.+9&*.12&*.==&0+14X2=&4+>&0+'6))=&
*(.:(&:4+&:40'2&/4+9=.+9&4+>&822>.+9&61)3=2;',
18. Cut off all bent and crimped wire.
The cut end must have no burrs or
sharp edges; cut again if needed.
19. Keep tension on the wire and guide at
least 12 inches of wire into the Wire
Inlet Liner and Feed Guide.
Incorrect – Connector not fully inserted
R0+&M43=2&
M)++2:/)1
O.12&@22>&
J2:(4+.';
Y+)3
Correct – Connector fully inserted
O.12&
@22>&
M)+/1)=&
M43=2
O.12&
F6))=
O2=>.+9&
O.12
]VPQ&OKU<&
F<MTU<PI
@22>&
R0.>2
O.12&K+=2/&
P.+21