Use and Care Manual

!
11!
www.titan-appliances.com
Operation
CHECK POINTS BEFORE OPERATION:
* Have you removed all packing materials and tape from the interior and exterior of the unit?
* Have you installed the unit properly by following the installation instructions?
* Has the unit been properly connected to the electrical outlet including proper grounding?
* Have you leveled the unit?
* Is the appliance properly located in an area where the ambient temperature is between 50°F
and 95°F all year round?
* Is the clearance of the unit, at least 2 to 3 inches at the rear provided for proper air
circulation?
THE CONTROL PANEL
You can set the temperature in the range of 38°F to 65°F (or 3°C to 18°C) .
BUTTONS
Power Button: Press and hold for three seconds to power on the unit. Once pressed the “Power”
indicator light will lit up to indicate the unit is running. Press and hold the button for three
seconds again, the unit will power off and the “Power” Indicator light will turn off.
Energy conservation button: Press and hold for three seconds to turn the energy conservation
mode ON/OFF. When this mode is turned on, the LED light and display will be turned off and
the °C/°F light will be on.
Light Switch: Press this button to turn on/ off the interior LED light.
Automatic mode:
The internal light will illuminate each time when the door is opened and fade off once the door is
closed. Press the light button to cycle through the different internal light color.
Display mode:
To switch between display mode and automatic mode, press and hold the light button for 3
seconds. The internal light will stay illuminated no matter the door is open or closed.
Increase Temperature: To adjust the temperature, press button to increase the temperature by
1-degree increments.
Decrease Temperature: To adjust the temperature, press button to lower the temperature by 1-
degree increments.
°C/°F This unit can be displayed in Fahrenheit or Celsius. Press button to change the setting.