OWNERS MANUAL SINGLE ZONE BUILT IN WINE & BEVERAGE COOLER COMBO TT-CBWC248422SZ
Table of Contents Table of Contents Important Safety Information Introduction Identification of Parts Installation Installation Clearance Requirements Electrical Requirements Leveling the Unit Installing the Door Handle and Shelves • • Operation • • DOOR HANDLE SHELVES 11 CHECK POINTS BEFORE OPERATION CONTROL PANEL Storage Sounds Defrosting Preparing the Unit for Storage Cleaning, Care and Maintenance • • 1 2 4 5 6 7 8 8 9 EXTERIOR INTERIOR Energy Saving Tips Trouble Shooting Specifications Warranty
Important Safety Instructions Improper handling can cause serious damage to the Titan appliance and/or injury to the user. This appliance is designed for domestic indoor use only. Use of the unit for industrial or commercial or any other purposes will void the warranty. Please read and follow all instructions before using the appliance to reduce the risk of fire, electric shock or injury.
Electrical ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ Plug the unit into a grounded 3-prong outlet. Do not remove grounding prong, do not use an adapter and do no use an extension cord. It is recommended that appliance be connected on its own circuit. Use outlets that cannot be turned off by a switch or a pull chain. The unit must be installed in accordance with state and local electrical codes.
Introduction Congratulations on purchasing your Titan appliance! We at Titan offer products with quality and features that compliment your lifestyle. To find out more about this product and our other products please visit our website at www.titan-appliances.com. This owner’s manual contains important information on how to install, use and keeping your appliance to work efficiently at its peak performance levels. To safely transport your appliance in future, please save the original product packaging.
Identification of Parts Note: Depending on the unit’s exposure level to odor, the carbon filter should be replaced every 3-6 months. If the unit is installed in kitchen the replacement should be carried out every 3 months. Tip: Please obtain the model and the serial numbers of the unit prior to installation. www.titan-appliances.
Installation Before installation, please check and ensure that: 1. The appliance should be installed in accordance with local electrical code requirements. 2. The appliance should be placed in a location that is strong enough to support its total weight – always assume the weight when the appliance is fully loaded. 3. The appliance must be placed in its upright position for at least 24 hours before plugging in and powering on to allow the compressor’s oil to settle. WARNING: Unpacking the Appliance 1.
Installation Clearance Requirements For built-in / under-counter installation, allow at least 2-3 inches of clearance at the back as shown in the below diagram to ensure proper service access and ventilation. The installation should allow adequate space for the unit to be pulled forward for servicing. The appliance should be placed on a firm and level surface and be able to support the weight when the unit is fully loaded. The appliance must be leveled in order to work properly.
Electrical Requirements WARNING - ELECTRICAL SHOCK HAZARD! è è è è è ALWAYS plug into a grounded 3-prong outlet. NEVER remove the grounding prong from the plug NEVER use an adapter to bypass the grounding prong DO NOT use an extension cord Failure to follow these instructions can result in fire, electrical shock, or personal injury. Please make sure you have the following: 1. Proper electrical connection before you move your appliance into its final location. 2.
Installing the Door Handle and Shelves THE DOOR HANDLE: 1. Open the door, carefully pull the door gasket around the area where the handle is to be installed, and remove the two pre-installed decorative plugs from the front of the door. (Note: some models do not have decorative plugs installed.) 2. Insert the Phillips head screws through the gasket side of the door and pass through the door. 3.
For glass shelves: To remove: • • • • Open the door all the way before pulling the shelves out of their track to prevent damaging the door gasket. Remove all the contents sitting on the shelf, if any. Tilt one side of the shelf up at a 30-degree angle. Then proceed to pull out the shelf slowly. www.titan-appliances.
Operation CHECK POINTS BEFORE OPERATION: * Have you removed all packing materials and tape from the interior and exterior of the unit? * Have you installed the unit properly by following the installation instructions? * Has the unit been properly connected to the electrical outlet including proper grounding? * Have you leveled the unit? * Is the appliance properly located in an area where the ambient temperature is between 50°F and 95°F all year round? * Is the clearance of the unit, at least 2 to 3 inches
INDICATOR LIGHTS AND DISPLAYS The unit is in cooling mode when this light is on. Displays the set temperature. F TEMPERATURE MEMORY This appliance memorizes and saves its set temperature. In case of a power outage, the unit adjusts to its previous temperature setting when power resumes. TEMPERATURE ALARM When the interior temperature is higher than 73oF (23oC), “HI” will be displayed on the panel and a buzzing alarm sound will go off.
Storage Wine bottles vary in size and dimensions. Titan wine cooler is crafted with professional wine enthusiasts and collectors who have sophisticated and diverse tastes in mind. Titan’s racks are designed to comfortably hold standard 750ml bottles without scratching the labels. The loading capacities include the following listed wine bottles. www.titan-appliances.
Sounds Some sounds and noises generated by this appliance may not be common to you, however most of these sounds are normal. Hard surfaces like floor and walls may make the sounds seem louder than they actually are. The following are the sounds you may be experiencing and what’s making them. • Rattling sounds – These may come from the flow of the refrigerant or the water line. Make sure nothing is stored on top of the appliance as this may damage the appliance and also create rattling sounds.
Cleaning, Care and Maintenance Proper maintenance and periodical cleaning will preserve high efficiency, peak performance, and long life of the unit. EXTERIOR CLEANING 1. Door and cabinet - a mild detergent and lukewarm water solution such as 2 tablespoons of baking soda to 1 quart of water. 2. If the door panel is stainless steel, clean with a cloth dampened with a mild detergent and warm water solution. 3. Use a soft sponge and rinse with clean water. 4.
Trouble Shooting PROBLEM The appliance does not turn on. The appliance turns on and off frequently. POSSIBLE CAUSE • • There is a power failure. The unit is not plugged in. • • • A house fuse has blown or the circuit breaker is tripped. • • The ambient temperature is too high. The door is being opened too often. The door is not closed properly. The door gasket is not sealing properly. Inadequate ventilation around the unit. The unit is installed too close to heat source(s).
Specifications MODEL VOLTAGE TT-CBWC248422SZ 115V/60Hz AMPS 1.5A INPUT POWER 120W CAPACITY 84cans + 22 bottles POWER CORD LENGTH 5.9ft TEMPERATURE RANGE 38 to 65 °F WEIGHT DIMENSIONS Including handle 101lbs 34.1H x 25.4D x 23.
PRODUCT WARRANTY ONE YEAR LIMITED WARRANTY THIS WARRANTY COVERS: • The original purchaser within all states in the continental United States (excluding Hawaii and Alaska) for one year from the date of purchase against defects in materials and workmanship under normal use and service. • Titan will be responsible for all transportation costs incurred in the event that service under this warranty is needed for the first 3 months from original purchase date.
