Installation Guide

3
Your air conditioner should be used in such a way
that it is protected from moisture,
condensation,splashed water, etc. Do not place or
store your air conditioner where it can fall or be
pulled into water or any other wet environment.
Unplug immediately
Always transport your air conditioner in a vertical
position and stand on a stable, level surface during
use.
Turn off the product when not in use.
Always contact a qualified person to carry out
repairs. If the supply cord is damaged it must be
repaired by a qualified repairer.
Keep an air path of at least 30cm all around the
unit from walls, furniture and curtains.
If the air conditioner is knocked over during use,
turn off the unit and unplug from the mains supply
immediately.
!
Always do this
Do not operate your air conditioner in a wet room
such as a bathroom or laundry room.
Do not touch the unit with wet or damp hands or
when barefoot.
Do not press the buttons on the control panel with
anything other than your fingers.
Do not remove any fixed covers. Never use this
appliance if it is not working properly, or if it has
been dropped or damaged.
Never use the plug to start and stop the unit.
Always use the switch on the control panel.
Do not cover or obsturct the inlet or outlet grilles.
Do not use hazardous chemicals to clean or come
into contact with the unit. Do not use the unit in the
presence of inflammable substances or vapour such
as alcohol, insecticides, petrol,etc.
Do not allow children to operate the unit
unsupervised.
Do not use this product for functions other than
those described in this instruction manual.
Never do this
Energy Save
Use the unit in the recommended room size.
Locate the unit where furniture cannot obstruct the air flow.
Keep blinds/curtains closed during the sunniest part of the day.
Keep the filters clean.
Keep doors and windows closed to keep cool air in and warm air out.
The air conditioner must be operated within the temperature range indicated below:
Operating condition
SAFETY PRECAUTIONS
Safety rules
To prevent injury, please read the following safety instructions. Improper use, or failure to follow
these instructions can cause serious damages.
Suggested tools for window kit installation
1. Screwdriver(medium size Phillips)
2. Tape
measure or ruler
3. Knife o
r scissors
4. Saw(In t
he event that the window kit needs to be cut down in size because
the window i
s too narrow for direct installation)
MODE ROOM TEMPERATURE
COOL
DRY
O O O O
17 C(62 F)~35 C(95 F)
O O O O
13 C(55 F)~35 C(95 F)
HEAT(heat pump type)
O O O O
5 C(41 F)~30 C(88 F)
HEAT(electrical heat type)
O O
<30 C/88 F