Use and Care Manual

12
12113. A /11" Position
• Adjust back massage position.
• Press A or 11" to choose position of massage rollers when a "beep" sound
alerts in 1O seconds.
• Release the button once the desired position is achieved.
Note:This can also be used during sector massages.
14. Vibration
• Prass this button once to activate the seat vibration function. Press the button
again to stop the seat vibration function.
• The vibration mode can be switched on or off while any of the programs are
running.
15. Heat
• Heat function is set to OFF by default.
• Press this button once to activate the waist heating function. Press the button
again to slop the waist heating function.
• It is applicable during any Automatic Program, Localised Area Program or
Manual Program.
16. Spot/Partial (S P)
• Press once to localize the massage to a particular point.
• Press again to shift massage to a particular area of body.
• This will keep the original massage node working on a range of 8cm.
• To resume full back massage, press button again.
17. Intensity
• Press this button to adjust kneading speed.
• After activating the Kneading function, every lime the button is pressed, the
speed can be adjusted in the cycle.
18.Speed
• Prass this button to adjust speed for Tapping, Shiatsu modes.
• After activating the Tapping or Shiatsu function, every time the button is
pressed, the speed can be adjusted in the cycle.