Installation Guide

Hinge
pins
face up
Use the measurement taken in step 2, mark each jamb (A,C) down from the top (see diagram, hinge pins face the top of the
jamb). Using a hacksaw and a metal cutting blade, trim the bottom of each jamb at the mark you made.
Top of hinge-side jamb (A)
(Warning: do NOT cut at top)
Top of latch-side jamb (C)
(Warning: do NOT cut at top)
Note: verify that
direction of hinge
pins match illustration
before cutting bottom
of jamb.
Bottom of
hinge-side jamb (A)
(CUT AT BOTTOM ONLY)
Bottom of
latch-side jamb (C)
(CUT AT BOTTOM ONLY)
Hold the hinge-side (A) jamb in place,
making sure the hinge pins face up
and the top end of the jamb is butted
up against the top jamb. Use a level
to ensure the jamb remains plumb and
mark through the holes A, B, C & D.
Drill four 1/8" holes 3/4" deep through
the marks you made on the frame. Put
the hinge-side jamb back in place and
mount it using four of the supplied
#8 x 1-1/4" mounting screws (H). Use
a level to ensure the hinge-side jamb
remains plumb as you install each screw
and adjust as needed.
Push jamb up
into corner tight
against the top jamb
Check with a level as
you mark each hole to
drill and again as you
install each screw
A
B
C
D
#8 x 1-1/4"
mounting
screws
Determining Your Build Out Area (continued)Trim the jamb
3
Determining Your Build Out Area (continued)Install the hinge-side jamb
4