Installation Guide

Determining Your Build Out Area (continued)Remove glass panel (optional)
1
If your door includes glass, remove it before you start the installation
procedure. Loosen (do not remove) each screw. Carefully hold the glass panel in
place and rotate each clip 90°. Carefully remove the glass panel and store it in a
safe place during installation.
Rotate
clips 90°
Determining Your Build Out Area (continued)Remove glass panel (optional)
1
Determining Your Build Out Area (continued)Install top jamb and measure length of side jambs
2
1. Center the top jamb (D) in the existing entryway opening against the edge of the door frame. Mark the frame through holes A &
B. Pre-drill two 1/8" holes 3/4" deep through the marks you made on the frame. Put the top jamb back in place and mount it to
the door frame through holes A & B using two of the supplied #8 x 1-1/4" mounting screws (H).
2. Measure from the top jamb (D) to the existing threshold at the front edge of the back of the door frame. You will use these
measurements in Step 3.
Door Frame
Side View
Front
Top jamb
Hole A
Hole B
Top jamb
Existing
entryway
Step A:
Install top jamb
Existing
threshold
Step B:
Measure side
jamb lengths
Existing threshold from
primary door