Installation Guide

E
F
G
H
Re-insert lock-side jamb (C). Check reveal by closing
door. Gap should be about 5/32". Use shims or spacers
to set reveal. Drill 1/8" holes 3/4" deep through the
mounting hole marks at E, F, G & H holes. Attach the
latch-side jamb using 4 of the #8 x 1-1/4" mounting screws
(H) provided, being sure to maintain the 5/32" reveal
throughout the mounting process.
Push jamb up
into corner tight
against the top jamb.
#8 x 5/8" self-tapping screws
Bottom
of door
Push the bug sweep (E) in place on
the bottom edge of the security door
and adjust it so that the rubber bug
sweep on the bottom lightly touches
the threshold. You may need to tap
the sweep in place using a wood
block. Pre-drill with 1/8" drill bit and
secure the sweep in place using 2 of
the #8 x 5/8" self-tapping screws (I)
provided. Be sure to keep your drill
on a low speed so that the threads
do not strip.
Check with a level as
you mark each hole to
drill and again as you
install each screw
Determining Your Build Out Area (continued)Install the latch-side jamb
8
Determining Your Build Out Area (continued)Install the bug sweep
9