Installation Guide

Hinge pins

Hang the security door (B) on the hinges, holding the door open to a 90 angle

and starting with the bottom pin first.

Applied to

door panel

Applied to

hinge jamb

Shim washer

Determining Your Build Out Area (continued)Install the door

Reminder: Maintain annually. Apply

white grease to hinge pins. (Hinge pins

come pre-lubricated from factory).

Following the manufacturer's instructions, install your choice of 2-3/8" backset handle

and lock set (Sold separately). Fully extend the lock bolts into the "locked" position on

the security door (B).

Determining Your Build Out Area (continued)Attach hardware, door closer and windchain (sold separately)

Follow the manufacturer’s instructions

included with the wind chain and door

closer to install on your new security door.

Note: It is not required to use a wind

chain and door closer for your security

door.

Determining Your Build Out Area (continued)Prepare latch and deadbolt clearance

Mark for latch and deadbolt clearance BEFORE permanently installing the

lock-side jamb.

Hold the lock-side jamb (C) in place, making sure the top end of the jamb is butted

up against the top jamb. Use a level to ensure the jamb remains plumb, mark the

mounting holes E, F, G & H, and the latch and deadbolt holes. Remove latch-side

jamb and use the 1/2" Spade drill bit to drill clearance holes in center of latch

and deadbolt markings approximately 1/4" deep.