Product Manual

PowrCoat 3
GB
Safety precautions
 • Followmaterialandsolventmanufacturer’swarningsand
instructions.Befamiliarwiththecoatingmaterial’sMSDS
sheet and technical information to ensure safe use.
 • Uselowestpossiblepressuretoushequipment.
 • Whencleaningtheunitwithsolvents,thesolventshould
never be sprayed or pumped back into a container with a
small opening (bunghole). An explosive gas/air mixture can
arise. The container must be earthed.
HAZARD: HAZARDOUS VAPORS
Paints, solvents, and other materials can be harmful
if inhaled or come in contact with body. Vapors can
cause severe nausea, fainting, or poisoning.
PREVENTION:
 • Wearrespiratoryprotectionwhenspraying.Readall
instructions supplied with the mask to be sure it will provide
the necessary protection.
 • Alllocalregulationsregardingprotectionagainsthazardous
vapors must be observed.
 • Wearprotectiveeyewear.
 • Protectiveclothing,glovesandpossiblyskinprotectioncream
are necessary for the protection of the skin. Observe the
regulations of the manufacturer concerning coating materials,
solvents and cleaning agents in preparation, processing and
cleaning units.
HAZARD: GENERAL
This product can cause severe injury or property
damage.
PREVENTION:
 • Followallappropriatelocal,state,andnationalcodes
governing ventilation, re prevention, and operation.
 • Pullingthetriggercausesarecoilforcetothehandthatis
holding the spray gun. The recoil force of the spray gun is
particularly powerful when the tip has been removed and
a high pressure has been set on the airless pump. When
cleaning without a spray tip, set the pressure control knob to
the lowest pressure.
 • Useonlymanufacturerauthorizedparts.Userassumesall
risks and liabilities when using parts that do not meet the
minimum specications and safety devices of the pump
manufacturer.
 • ALWAYSfollowthematerialmanufacturer’sinstructionsfor
safe handling of paint and solvents.
 • Cleanupallmaterialandsolventspillsimmediatelytoprevent
slip hazard.
 • Wearearprotection.Thisunitcanproducenoiselevelsabove
85 dB(A).
 • Neverleavethisequipmentunattended.Keepawayfrom
children or anyone not familiar with the operation of airless
equipment.
 • Deviceweighsinexcessof36kg.Three-personliftisrequired.
 • Donotsprayonwindydays.
 • Thedeviceandallrelatedliquids(i.e.hydraulicoil)mustbe
disposed of in an environmentally friendly way.
1.2 Compressor Safety
PowrCoat units are Air-Powered (powered by an air compressor).
Follow all safety precautions given by the compressor manufacturer
regarding electrical and general safety.
Locatethecompressoroutsidetheimmediatesprayingareatoavoid
clogged air intake of the compressor with overspray.
If lacquer or other flammable materials are to be
sprayed, ALWAYS locate the compressor outside the
immediate spraying area. Failure to do so may cause
an explosion.
1.3 Setting up on uneven surfaces
The front side of the unit must point downwards to prevent sliding
away.
Operating Temperature
This equipment will operate correctly in its intended ambient, at a
minimumbetween+10°Cand+40°C.
Relative Humidity
The equipment will operate correctly within an environment at 50%
RH,+40°C.HigherRHmaybeallowedatlowertemperatures.
Measures shall be taken by the Purchaser to avoid the harmful eects
of occasional condensation.
Altitude
This equipment will operate correctly up to 2100 m above mean sea
level.
Transportation and Storage
This equipment will withstand, or has been protected against,
transportationandstoragetemperaturesof-25°Cto+55°Candfor
shortperiodsupto+70°C.
It has been packaged to prevent damage from the eects of normal
humidity, vibration and shock.