Product Manual

PowrCoat 13
GB
Troubleshooting
7. Troubleshooting
7.1 Airless Gun
Problem Cause Solution
A. Spitting gun 1. Air in system
2. Dirty gun
 3. Needleassemblyoutofadjustment
4. Broken or chipped seat
1. Inspect connections for air leaks.
2. Disassemble and clean.
3. Inspect and adjust.
4. Inspect and replace.
B. Gun will not shut o 1. Worn or broken needle & seat
 2. Needleassemblyoutofadjustment
3. Dirty gun
1. Replace.
2. Adjust.
3. Clean.
C. Gun does not spray  1. Nopaint
2. Plugged lter or tip
3. Broken needle in gun
1. Check uid supply.
2. Clean.
3. Replace.
7.2 Air Motor
Problem Cause Solution
A. Motor stops at top or bottom
of stroke - air does not exhaust
when gun is open.
1. Piston rod is loose where it connects to the
uid section.
2. Trip springs or valve spring broken.
3. Motor is frozen due to icing or lack of
lubrication.
1. Tighten connection.
2. Inspect and replace where neessary.
 3. ChecktheAir-Care™uidlevelintheAutomatic
Lubricator.Iflow,addAir-Care™toreservoir.
If condition persists, check air supply for
contamination.
B. Motor stops, blows air from
exhaust when gun is open.
1. See above.
2. Air valve is in dead stall position.
3. O-rings were worn or damaged.
1. See above.
2. Remove one trip spring retainer, trip spring and ball.
Push spool valve up or down, lubricate, reassemble
and restart.
3. Install minor service kit and follow instructions in
Servicing section of manual.
If dust or dirt is found inside motor, check air supply for
contamination.