Operating Guide

For most situations, you can

make a cut line anywhere

up to 2.5" back from the tip

These cuts can be angled or

straight (no usable difference)

The Andersen Camper Leveler (part #3604) can be trimmed to ﬁt

into tighter wheel spacing as shown below.

In really tight situations, you can

make your cut line anywhere

up to 4" back from the tip (max

point between 1st and 2nd hole)

4-1/4"

15-5/8"

PAGE 1
The Andersen Camper Leveler (part #3604) can be trimmed to fit into tighter wheel spacing as shown below. For most situations, you can make a cut line anywhere up to 2.
PAGE 2
QUESTION: What is the minimum distance between wheels that is needed for the Camper Leveler to work? ANSWER: Tire size and spacing can vary a lot from trailer to trailer —bigger @res can be closer together (Fig. 1), but smaller @res have less ground clearance so they need to be further apart for the Camper Leveler to ﬁt (Fig.
PAGE 3
Figure 3 Figure 4