Full Product Manual

8
Refueling
• Always turn the engine off and allow adequate time for it to cool before refueling. ONLY USE
UNLEADED FUEL WITH 86 OCTANE OR HIGHER.
• NEVER refuel your driver with the engine hot, running, or in an unventilated area. Fuel vapors are
extremely flammable and can cause severe injury or death if ignited by a spark or excessive heat
from a hot engine.
• Fill the tank on level ground and avoid spilling the fuel on the motor. Always allow any spilled fuel to
evaporate before restarting the engine.
• Ensure the fuel cap is adequately tightened before restarting the engine.
Installing the Adapter Sleeve
• A 1” adapter sleeve is included with each PGD2000 Post Driver. This sleeve allows you to drive items
that
are ¾” to 1” in diameter. A 2” adapter sleeve is included with each PGD3200 Post Driver. This
sleeve allows you to drive items that are 1” to 2” in diameter.
Additional sleeves are available for the PGD2000 to use for items less than ¾” in diameter.
• A ¾
” sleeve is available for items that are ½” to ¾” in diameter.
• A ½” sleeve is available for items less than ½” in diameter.
• To install the adapter sleeve, simply slide it into the barrel. Friction fit pads will hold it in place.
See Figure 2.
Figure 2: Installing the adapter sleeve for the PGD2000