User's Manual

ALTIMETER
THERMO
Indication of altitude in relation to sea level
Indication of the temperature
(1)
Activation of the crystal
(1) The altitude is displayed in metres or feet depending on the units selection (see
“Selecting the units” on page 6). After 30 seconds, the hands show the time again
but the digital display remains in ALTIMETER mode.
After 10 h, the digital display returns to “h-m-s” mode
(2) The adjustment shows the altimeter setting at the value of the actual altitude. For
more information, see the explanation of the altimeter on page 12.
(1) To obtain the best reading, it is necessary to remove the watch from your wrist
and wait for approximately 15 to 30 minutes.
For more information, see the explanation of the thermometer on page 13.
(2) The temperature is displayed in degrees Celsius or in degrees Fahrenheit depen-
ding on the units selected (see “selecting the units” on page 6).
After 30 seconds, the hands display the time again but the digital display remains
in THERMO mode.
Activation of the altimeter
function
(1)
Adjusting the altitude
(2)
Incrementation or decrementa-
tion (1 m or 3 ft)
Validation of the setting
Activation of the crystal
Activation of the thermometer
function
1”
2”
+ or - 1 step
1”
138_en / 01.07
9/14 www.tissot.ch