Product Manual
Adding, Disconnecting and Swapping Vehicles
The TireMinder
il0
can add
or
disconnect up
to
4 different vehicles using Disconnect
(D)
Mode. To
do
so, please
use
the
following directions:
1.
From Monitoring Mode, press and hold
the
left and
center
buttons
for 5 seconds, until you hear a beep.
2.
After
the
beep, you
will
see a
"D"
in
the
center
of
the
display. You
will
also see
the
tire positions flashing,
along with either
FRONT or
REAR
and number
to
the
right. The flashing section represents
the
currently
selected section and
the
number represents
the
vehicle number.
For
example,
if
you see
the
FRONT and
a 1
is
displayed,
that
means
that
you are on
the
first vehicle
of
the
front
section.
3.
From here, you can use
the
right
button
to
toggle
between
vehicles. 1
is
the
first vehicle, 2
is
the
second
vehicle and 0
is
...
no vehicle! When 0
is
selected, no vehicle
will
be displayed
in
that
section.
In
other
words, it's disconnected.
4.
To toggle
between
sections, press and release
the
center
button.
Each
section
is
notated
by either
FRONT or
REAR
on
the
monitor.
5.
Once you have made your selection, exit Disconnect Mode by pressing and holding
the
left and
center
buttons
for 5 seconds, until you hear a beep. You
will
then
be back
in
Monitoring Mode.
If
you ever need
to
reconnect
a vehicle, go back into Disconnect Mode and choose
the
appropriate section and
vehicle you desire.
To
add a
new
vehicle, change
the
vehicle number
to
one
you are currently
not
using. Then, go into Learning
mode
and
repeat
the
same procedure from page
2.
Have a question
about
adding, swapping,
or
disconnecting vehicles? Please visit www.TireMinder.com/ilO for
instructional videos. You may also give
us
a call and we can walk you through
the
process.