User Manual

Version 1.2 User’s Manual 11
5.2 Retrain System for Some Tires
• To retrain system for tire rotation or replacement with less than
all the tires, get into the Manual Tire Setup screen as described
above, press the Control Button to move the blinking icon to the
desire tire location, and then release the associated tire air as
described earlier to set it up.
• Note that each skipped tire will retain its previous sensor
assignment, and this sensor will not be accepted for assignment
to another tire location.
• Press the Setup Button for 3 seconds on the blinking tire icon will
clear its sensor assignment.
• If there are more tire setup then press the Control Button again
for moving the blinking icon to the next desire tire location, and
then repeat set up procedure.
• Press the Control Button passing the last tire icon to exit the
setup and save the new setting.
5.3 Change Display
Press the Control button to get to the Change Display screen, indicate
by a Cd on the screen (showed above). One display mode continuously
shows tire readings while the other mode turns off the showing after 8
seconds. Press the Setup button in this screen toggles the display
configuration from one mode to the other.
Version 1.2 User’s Manual 12
Appendix: Trailer TPMS
Tire-Safeguard supports Trailer tire pressure monitoring. A truck-trailer
TPMS display will first show the truck screen and then the trailer screen.
The user may press the Control Button to retrieve individual tire status. If
the system is configured with a towed vehicle, it will include features
described below.
A.1 Trailer Screen
Trailer TPMS has a dedicate
screen for showing tire
information, where the
vehicle graphic looks slightly
different than the towing
vehicle graphic
A.2 Trailer Pressure Warning Threshold Set Up
Trailer TPMS has its own screens to setup the warning threshold for
tire pressure. Simply follow the truck system setup procedure
described earlier, after the truck tire pressure threshold screens there
will be the Trailer threshold setup screens for high and low tire
pressure. Setup steps are similar.
A.3 Retrain System for All Trailer Tires
The Trailer TPMS has its
own Trailer Manual Setup
screen, which is in the same
group with the tractor setup
screens showed earlier.
• On the Display unit, press and hold down both the Setup and the
Control buttons, after 6 seconds the system enters the Tire Setup
Select Mode. Release both buttons.
• Press the Control Button to change to the Trailer Manual Setup
screen as showed above.
• Press the Setup Button at this screen; the No. 1 tire indicator starts
blinking.
• Set up sensor-tire in the same procedure as for the tractor.
A.4 Retrain System for Some Trailer Tires
To retrain system for tire rotation or replacement with less than all the
tires, get into Trailer Manual Setup screen and follows steps similar to
truck partial retraining procedures.