Instructions / Assembly

Pre-ride Checklist
Please make sure the brake lever sequence is
correct for your country before riding. In UK, NZ and
Australia the left brake lever is for rear brake and
the right brake is for the front brake. In all other
countries it is the other way: left for front, right for
rear.
Check the tyres for any visible damage.
Check tyre pressures are 30psi, and adjust if
necessary.
Check for any loose nuts, bolts, or fixings.
Check brake functions, cable tension, pad
clearance, etc.
Check all electronic functions are ok (functions
detailed later in this manual).
Check the reflectors are in place and the lights are
working (detailed later in manual).
Torque Settings
Check bolts are tightened according to the following
recommendations before you set off for the first time.
c. Front wheel axle nuts 30-35N.M
d. Seat angle clamp bolt 24N.M
e. Crank axle nuts R:42N.M
L: 46N.M
f. Gear shifter nuts 4N.M
g. Rear carrier nuts 8N.M
h. Mudguard bracket nuts 8N.M
I. Handle bar clamp nut 17-20N.M
j. Quill stem bolt 19N.M
k. Seat tube clamp nut 4-7N.M
l. Rear wheel axle nuts 40-45N.M
m. Quick release front axle. Measured torque not
typically used. Common industry practice is resistance
at lever half way through swing from open to fully
closed.
For all other nuts, the torque depends on the nut
diameter: M4 2.5-4.0N.M
M5 4.0-6.0N.M
M6 6.0-7.5N.M
Note: make sure axle nuts are always done up tight on
both wheels as connections to the motor and the
dropouts can be damaged due to the axle spinning.
a. Seat pillar clamp nut/bolt 5N.M-8N.M
b. Brake cable anchor bolt 5N.M
Safe Riding Recommendations