Instructions / Assembly

P05: Power Assist Gear
0/3 Gear Mode: Gear 1: 2V Gear 2: 3V Gear 3: 4V
1/5 Gear Mode: Gear 1: 2V Gear 2: 2.5V Gear 3: 4V
Gear 4: 3.5V Gear 5: 4V
P06: Wheel Diameter Unit: inch Precision: 0.1
P07: Magnet Steel Number (for Speed Test)
Range: 1-100
P08: Speed Limit
Range: 0-50km/h, parameter 50 indicates no speed
limit.
1. Non-communications status (panel-controlled)
When the current speed exceeds the speed limit, the
PWM output will be shut down; when the current
speed falls to lower than the speed limit, the PWM
output will be activated and the driving speed will be
set as the current speed ±1km/h (only applies to
assist power speed, not applicable to the handlebar
speed).
2. Communications status (controller-controlled)
The driving speed will be kept constant as the limited
value.
Error Value: ±1km/h (applicable to both the assist
power/handlebar speed)
Note: The above-mentioned values are measured by
metric unit (kilometers). When the measuring unit is
switched to imperial unit (mile), the speed value
displayed on the panel will be automatically switched
to corresponding imperial unit, however the speed
limit value in the imperial unit interface won't change
accordingly.
P09: Direct Start / Kick-to-Start Setting
0: Direct Start
1: Kick-to-Start
P10: Drive Mode Setting
0: Power Assist – The specific gear of the assist
drive decides the assist power value. In this status
the handlebar does not work.
1: Electric Drive – The vehicle is driven by the
handlebar. In this status the power gear does not
work.
2: Power Assist + Electric Drive – Electric drive
does not work in zero-start status.
P12: Power Assist Intensity Range: 0-5
P13: Power Magnet Steel Number 5 / 8 / 12pcs
P14: Current Limit Value: 12A by default; Range: 1-
20A
VLCD Display Panel Controls