Instructions

6
Step 5:
Bring the bracket close to the two Mantis, slowly move the Mantis until the bracket
screws align with the Mantis screw holes and attach the bracket. Using the Philips
screwdriver, slowly start screwing them in, one by one with just a few turns. If one of
them feels too sti it might not be aligned with the rail, try to unscrew it and check the
alignment. Do not screw in if it feels hard to turn as it might damage the thread on the
Z-Rail.
After all screws are all the way in, tighten them just a bit. We will tighten them completely
at the end.