Operation Manual
Setting up
11
can lead to damage to health or personal injury. Do not use any other
types of chargers. This could damage the batteries.
Replace the cover (see Fig. on the right of page 10) and tighten the screw.
Inserting plate and plastic cover
Enter your own call number and the call numbers for the police and fire service in
the appropriate fields. Slide the label flat into the recess under the clips (see Fig.
on the left). Slide the cover over them (see Fig. on the right).
You can remove the cover by inserting a paper clip into the groove and slowly and
carefully lifting the cover. Once you have released the cover from the two lower
clips, you can remove it from the recess. Repeat this procedure for the label.
Placing the handset on the base station
Place the handset on the base station with the display pointing upwards. The
confirmation tone sounds and the red LED on base station lights up.
Leave the handset in the charging cradle so that the batteries can be charged.
The fist time you charge the batteries, we recommend an uninterupted
charging time of at least 15 hours, regardless of the charge level
display.
When the batteries are new, they doesnt provide 100% of them
efficiency; it means that they might be discharged earlier. To reach the full
battery duty, you have to run-in the batteris with at least 3-4 deep
charging / discharging cycles, after that they will reach their maximum