Operation Manual

Setting up

Connect telephone to Power

Plug the AC adapter cable plug into the socket with the mains symbol. Place the

cable in the appropriate cable duct. Then plug the AC adapter into a 230V socket.

Removing the cables

First of all unplug the AC adapter from the 230V socket and then remove the TAE

plug from your telephone connections TAE socket.

To remove the cables on the underside of the telephone press (e.g. with a ballpoint

pen) the plugs locking clips towards the body of the plug and pull out the plug by

the cable.

Setting up the handset

Opening the battery compartment and inserting the batteries

The battery compartment is on the rear of the handset under the Police / Fire

label. The cover of the battery compartment is screwed down for safety reasons.

This means that the compartment cannot accidentally open and that the batteries

are securely fitted.

 Unscrew the screw using a Phillips screwdriver and remove the battery

compartment cover (not necessary for initial installation).

 Insert the attached batteries (NiMH = Nickel metal hydride), with the correct

polarity (see Fig. on the left). You will hear a confirmation tone.

Only insert recommended, rechargeable batteries of the same type

(NiMH, 1200 mAh and higher). Never use ordinary batteries, as this