Operation Manual

English

Technical characteristics

Line interface: according TBR37 and TBR38

dialling: DTMF

CLIP: FSK

Frequency: 1,8 GHz DECT

Extensions per base station: Up to 4

Data rate: V.90/V.92 and V.34 modem up to 56Kbit/s

(minimum of 28.8Kbit/s)

Range: 300 m (outside), 50 m (inside)

Power supply: 230V +/- 10%, integrated

Power consumption: <1.0W (idle), <2.0W (active)

Telephone cable: Length 1.5 m

Dimensions (WxHxD): 95 x 60 x 75 mm

Weight: <100 g

Ambient temperature: 10°– 40°C, for indoor use only

Registration procedure for a DECT GAP handset

Make sure both base unit and extension unit are powered on and an extension

unit is registered. You may register up to 4 extension units/handsets.

After powercycling the base unit twice the LED is fast green blinking and open for

registration of a handset. Repeat the procedure after one minute in case it does

not start blinking fast.

The GAP handset can be registered using the handset registration procedure, PIN

(AC) code is “1234” for the base unit.

After successful registration the base unit stops blinking and you can use the

handset in parallel with the extension unit. To make a global call to all parallel

devices use the key “internal” first followed by any number. Dial “#” with analogue

devices connected to an extension unit followed by any number. It is not possible

to call specific devices.