Technical data

Settings
97
When entering digits press the
selection button next to the desired
line.
The entry location flashes.
Change the settings using the
control buttons (up/down).
The display counts up or down.
For settings with several digits
move the entry location to the
required location using the control
buttons (left/right).
The selected entry location flashes.
To end digit entry press the
selection button next to the desired
line again.
The entry location stops flashing.
To stop the entry press stop several
t
imes.
The initial state is again displayed.
Adjusting the volume
You can set the volume when the device is in the initial state.
Set the volume using the control
buttons (left/right).
The volume bar shows the current
setting.