Technical data

Settings

Call-back code ...................... You enter the call-back code of your network

operator (for Deutsche Telekom network e.g.

H*37#). The "H" refers to the request key with hook

flash- function. You can enter up to 15 characters.

PABX ...................................... >>

Prefix .......................... Enter your prefix for the public telephone network

e.g. 0) here. This prefix is dialled automatically

before each call number unless the call number is

marked with an "i" as an internal call number within

the PABX.

CLIP correction ......... Some PABX systems add in numbers before the

received call number. This produces incorrect

messages for the received call number. In order to

recognise the additional numbers and to cut them

off you can enter them here.

Call-back code .......... Enter your call-back code for your PABX (e.g. 79)

here. You can enter up to 15 characters.

Message tone ....................... Volume levels 1 to 4 or off. If you activate the sound

by setting the volume each time a new ICM is

received a message tone sounds every 10 seconds.

Contrast ................................. You can set the screen contrast in up to 16 steps

here.

Brightness .............................. You can set the screen brightness in up to 16 steps

here.

Backlight ................................ Automatic or on. For the "automatic" setting the

backlight is switched off automatically after 10

seconds. If you want the backlight on continuously,

select "On". Please note that the power

consumption in standby will then exceed 1 Watt.

Fußschalter ........................... „Philips“ oder „Uher“. Wählen Sie hier den

entsprechend korrekten Fußschalter aus, welchen

Sie mit dem Gerät verbinden möchten.