Technical data

Appendix
104
CE symbol
This device is authorised for connection to the analogue public telephone network
in all EU member states in line with European requirements. As a result of technical
differences in various countries however there is no unlimited guarantee that the
device will work successfully in any telephone connection.
Tiptel.com GmbH Business Solutions herewith declares that the equipment
complies with all the fundamental requirements of European Directive 1999/5/EC.
Conformity is confirmed by the CE symbol affixed to the equipment. Further details
concerning the conformity declaration are available at the following Internet
address:
http://www.tiptel.com
Troubleshooting
Power failure
The device is not operational during a power failure. The internal clock stops. But all
settings are retained so that the previous status is reset when power returns. You
may need to reset the time.
Using the following table try to define the cause of a problem and solve the error.
Problem Possible cause Remedy/Recommendation
No display. No contact with mains power
supply.
Check all cables and plugs. If
necessary try another plug.
Display too weak or dark. Contrast set incorrectly. Set contrast.
No sound. Volume set to zero. Adjust volume.
OGM symbol flashing. No OGM recorded. Record an outgoing message.
No answer, no monitoring. No contact with connection
cable.
Check all cables and plugs.
No response in PABX. No call signal switched on. Check PABX programming.
Buzzing or other interference
on loudspeaker.
Interference from cordless
telephone, monitor etc.
Chang installation location.
Messages not recorded. Device is set to OGM without
ICM option (message only).
Change or re-record OGM.