Technical data

Operation

Note: Please, check flash timing in case of problems. PABX setting usually is

100 ms while network providers may use 100 ms or 300 ms. Please, ask

your network provider or PBX installer (in case this device is used behind

a PABX) for the appropriate setting.

Pre-dial

In on-hook status, type in the phone number and then pick up the handset. The

number will be dialed automatically.

Pause

Press / P for a break off of 1.2/2.4/3.6 seconds (depending on setting).

Redial / Auto redial

In on-hook status, press / P to review the last 16 dialed numbers.

Pick up the handset or press to dial the reviewed number.

Speed Dial Memories

Store

In on-hook status, press .

Input the phone number you wish to store as one of the speed dial memories.

Press the specific one-touch speed dial memory key (M1~M3) which you would like

to save the phone number with to finish the setting.

Dial

Pick up the handset or press . Press M1 (M2~M3) to dial the stored phone

number automatically. Or: In on-hook status, press M1 (M2~M3) to see the stored

phone number. Press

or pick up the handset to dial the number.

Delete

In on-hook status, press M1(M2~M3) to see the stored phone number.

Press X/MENU several times to delete single digits (from backwards).

Press and hold X/MENU for 3 seconds to delete the complete number shown.