User Manual

5
E
N
G
L
I
S
H
Barrel Blocking Device Installation Instructions
1. Insert the barrel blocking device onto the Barrel, and loop the cord over the Air Supply
Adapter (ASA) and position at the back of the grip as shown.
2. Adjust the cord length
retainer up to the back
of the grip by pulling
the cord through it until
the retainer is snug
against the back of the
grip. Keeping the cord
as tight as possible,
leave just enough cord
elasticity to remove
the cord/retainer from
under the marker to
remove the barrel
blocking device for ring.
3. After the cord length is properly adjusted, lock
the cord length by tying a knot in the cord
against the back of the retainer as shown.
4. Before and after playing, inspect the barrel
blocking device. Replace the barrel blocking
device if the device or cord is damaged, or there is a loss of cord elasticity.
5. Clean the barrel blocking device with plain, warm water and store out of sunlight in a dry
area when not in use.
WARNING
This product contains one or more chemicals that are known
to the State of California to cause cancer and birth defects
or other reproductive harm. Wash hands after handling.
WARNING
Always keep the barrel blocking device installed except when
your marker is in use. Always make sure that the Safety
is in the safe mode (see instructions on page 6) and the
barrel blocking device is properly installed on your marker
according to the instructions to prevent damage to property,
serious injury, or death.
Barrel Blocking Device
Cord Length
Retainer
Cord Length Retainer and Knot