User Manual

20
E
N
G
L
I
S
H
Disassembly of Bolt System
Remove stock and rear shroud assembly by removing two hex head
screws (shown on page 18). Use a hex wrench or your hand to unscrew
back cap from marker body. When removing the back cap, the bolt
may be left inside the body. The bolt can be pulled out from the rear of
the marker. You can perform general maintenance like lubricating and
replacing O-rings.
Removal of Grip Frame and Regulator
1. Remove stock and rear shroud assembly as shown in Stock Assemblies on page 18.
2. Remove the feedneck by pressing the button on the feedneck then sliding it forward and
off the rail system.
3. Remove the 3 remaining screws holding the body shell together then remove the two
body shell halves.
4. Remove the 2 screws on the bottom of the ASA that hold the ASA in place. On the
bottom side of the grip frame remove the 2 screws, 1 just above the trigger and 1 above
and behind the grip.