Owner's Manual

ManualsBrandsTippmann ManualsPaintballM4 .68Cal Marker

TP04405 Rev. 07/16

10. Remove the Charging Handle (25) by lifting it

from the receiver half.

11. Disconnect the Linkage Arm (47) from the Rear

Bolt (9) and Front Bolt (23). You may need to lift

the Valve assembly slightly.

12. Slide the Front Bolt off the Power Tube (22) and

check the O-Ring (24). Clean and oil the O-Ring or

if damaged, replace with a new one. Do the same

with the Rear Bolt O-Ring (10).

13. To disassemble the

Trigger (49), rst

remove the Trigger

Linkage Arm

(48).

The Trigger can be

removed from the

marker, but be sure to

capture the Trigger

Spring

(50) when

removing the Trigger.

The Trigger Adapter

(55) assembly can be

removed from the pins

(51) if desired.

14. The Sear (52) lifts off

of the Sear Pin (54),

be sure to capture the

Sear Spring (53) during disassembly of the

Sear. Note that the Sear Spring is colored gold.

Power Tube and Valve

Refer to the Parts Diagram for these instructions.

NOTE: Do not remove the Gas Line Joint (35)

unless it is leaking or you need to replace the valve.

If you do, use teon tape or thread paste on the

joint threads before reinstalling it. Carefully hand start all threaded parts, be careful because

overtightening could strip threaded parts when assembling.

1. To remove the Air Valve (11) from the Power Tube (22), use a wrench to slowly

unscrew the Gas Line Joint (35) from the Valve. Once the Gas Line Joint is removed

from the Air Valve body, the Air Valve will slide out the back of the Power Tube.

2. NOTE: Check the Air Valve’s external O-Ring (13) and if damaged, replace with a new

one. If the O-Ring is damaged your marker will not operate correctly.

Clean all parts and lightly oil the O-Rings.

3. Insert the cleaned and lightly oiled Air Valve into the Power Tube. Apply teon tape or

thread paste to the threads of Gas Line Joint and carefully thread it into the Valve. Snug

with a wrench (do not over tighten and possibly strip the threads). Wipe off any excess

thread paste if used.

4. Reinstall the Power Tube/Air Valve into the receiver half.