Owner's Manual

TP04405 Rev. 07/16

Marker Disassembly Instructions

Set up a workbench with plenty of workspace to make sure no small parts become lost.

Always wear eye protection (like safety glasses) when performing any marker disassembly

or re-assembly. Refer to the Parts Diagram for these instructions (item numbers

are in parentheses). When disassembling the marker, pay close attention to how the parts t

together to make later re-assembly easier and accurate. These illustrations show the hopper

fed marker, but apply to the magazine fed marker as well.

1. Follow Unloading Your Marker on page 10 and Air/CO2 Cylinder Removal instructions

on page 12. Make sure there isn’t a paintball in the chamber.

2. Put the marker into the uncocked position. Set the Safety Selector Switch (39) to

the Fire mode. Pull the Trigger to release the bolt.

3. Remove the Barrel (27), turn the Barrel counterclockwise from the Receiver. To reinstall

it, turn it clockwise to thread it into the Receiver. Make sure the O-Ring (26) is lubricated

with Tippmann Certied Marker Oil when re-assembling the barrel to the marker.

4. Remove the Rear Sight (92) from the marker.

5. Remove the Feed Tube Assembly (66). Unscrew the Locking Cap (65) from the

Feed Tube and swing it out to remove it from the marker. You must remove the Feed

Tube to remove the fake magazine from the marker.

6. Remove the Magazine, from the right side of the marker, press the Magazine Release

Button

(45) in, and slide the magazine out the bottom of the marker. The fake magazine

contains the ball latch. If converting to Magazine Fed, the fake magazine needs to be

removed.

7. Remove Screw (41A) from the left side of the marker. Pull the Front Shroud assembly

from the marker.

8. Remove the remaining Receiver Screws (41, 42, and 46) shown above. Remove Screw

(59) from the right side Grip. Remove both Grips from the marker. Pull straight down on

the ASA (32) to remove it from the Gas Line (34).

9. Put the Safety Selector Switch in the Fire position (as shown above) and pull in the

Trigger. While holding the Trigger in, place one hand inside the magazine well and

carefully lift the left-side receiver to access the internal parts. The Safety Selector

Switch and Magazine Release mechanism stay with the left Receiver Half.

41a