User Manual

E
N
G
L
I
S
H
TP04225 Rev. 11/14 9
3. Firing Your Marker
a. Gotoadesignatedringarea,removethebarrelblockingdevice,andmovethe
TriggerSafetytoFiremode(seepage6).
b. Pointyourmarkerinasafedirectionandpullthetriggertorethemarker.
c. Whennishedringthemarker,puttheTriggerSafetyinSafemode(page6)and
installthebarrelblockingdevice(page4).
4. Velocity Adjustment
Eachtimeyouplaypaintball,checkthevelocityofyour
paintballmarkerwithachronograph(aninstrumentfor
measuringvelocity)priortoplayingpaintball.Verifythat
themarker’svelocityissetbelow300feetpersecond
(orlessifrequiredbytheplayingeld).
Toadjustthemarker’svelocity,usetheincluded3/16”
Allenwrench.Thevelocityadjustmentscrewislocated
onleftsidereceiver.Toreducethevelocity,turnthe
screwinwardorclockwise.Toincreasethevelocity,turn
thescrewoutorcounterclockwise.Donotremovethe
velocityscrew.
Unloading Your Marker
1. Eyeprotectiondesignedforpaintballusemustbewornbytheuserandanyperson
withinrange.TheTriggerSafetymustbeinSafemodeandthebarrelblockingdevice
mustbeinstalled.
2. EmptyallpaintballsfromtheHopper.
3. UsingtheincludedAllenwrench,loosentheHopperBoltandremovetheHopperfrom
theFeedElbow.
4. Gotoadesignatedringarea,removethebarrelblockingdevice,andmovetheTrigger
SafetytoFiremode(seepage6).
5. Pointyourmarkerinasafedirectionandreseveraltimestobesurethereareno
remainingpaintballslodgedinthechamberorbarrel.IMPORTANT:Donotuncockyour
markerasuncockingyourmarkermaypushaballintothechamberordownintothe
barrelinwhichcasetheballwillbehiddenfromview.
6. ReturntheTriggerSafetytotheSafemode(seepage6)andreinstallthebarrel
blockingdevice(seepage4).
7. ReadthefollowingAir/CO2SupplyCylinderWarningsandSafetyTipsbeforeremoving
theair/CO2cylinderfromyourmarker(removalinstructionsareonpage12).
Figure 3: Use a 3/16” Allen wrench
to adjust the velocity.
Velocity Adjustment
Screw Location