User Manual

4
E
N
G
L
I
S
H
WARNING
Always keep the barrel blocking device installed except
when your marker is in use. Always make sure that the
Selector Switch is in the Safe mode (see instructions on
page 6) and the barrel blocking device is properly installed
on your marker according to the instructions to prevent
damage to property, serious injury, or death.
Barrel Blocking Device Installation Instructions
1. Place the barrel blocking
device onto the Barrel, and
loop the cord over the top
of the receiver and position
at the back of the grip as
shown.
2. Adjust the cord length
retainer up to the back of
the grip by pulling the cord
through it until the retainer is snug against the back of
the grip. Keeping the cord as tight as possible, leave
just enough cord elasticity to pull the cord/retainer up
over the top of the marker to remove the barrel blocking
device for ring.
3. After the cord length is properly adjusted, lock the cord
length by tying a knot in the cord against the back of the
retainer as shown.
4. Before and after playing, inspect the barrel blocking
device. Replace the barrel blocking device if the device or cord is damaged, or there is a
loss of cord elasticity.
5. Clean the barrel blocking device with plain, warm water and store out of sunlight in a dry
area when not in use.
WARNING
This is not a toy. Misuse may cause serious injury or
death. Eye, face, and ear protection designed for paintball
must be worn by the user and any person within range.
We recommend you be at least 18 years old to purchase.
Persons under 18 must have adult supervision when
using this product. Read the Owner’s Manual before using
this product.
Barrel Blocking Device
Cord Length
Retainer