User Manual

13
E
N
G
L
I
S
H
1. Use trigger pulls to get the bottom LED showing the desired color (of those above).
2. Use an extended trigger pull (approx. 2 seconds) to select the desired color/re mode.
3. The bottom LED ashes four times in the chosen color to conrm that your choice is
saved in memory and software reverts back to the Enter Programming menu.
4. Continue with further programming (use a short trigger pull), or go to
Saving the
Program Settings
(page 14) when nished making changes.
Advanced Programming (Yellow middle LED)
Bottom LED shows these choices:
Red > Dwell
Green > Debounce
Blue > Rate of Fire (ROF is programmed
individually and is Fire Mode
specic; ROF is not global to all
ring modes, a change to this
setting only changes the ROF of the
currently selected Fire Mode.)
Dwell Programming (Red LED) It is strongly
suggested that the Dwell setting not be changed.
1. Pull the trigger until the bottom LED is red.
2. Use an extended trigger pull (approx. 2
seconds) to select the Dwell menu. Upon
trigger release, the bottom LED ashes the
current setting.
3. Pull the trigger one time for each number of
the desired setting (LED ashes red once for
each trigger pull):
Starting with the rst ash at 0.5msec, each
extra ash adds a half millisecond. (We
recommend not changing the dwell setting,
but if you do, use settings between 10
ashes (5 msec) and 18 ashes (9 msec).
Do not use settings in the shaded area of the
table.
4. Use an extended trigger pull (approx. 2
seconds) to save the setting. The bottom
LED ashes the new setting.
5. Continue with further programming (use
a short trigger pull), or go to
Saving the
Program Settings
on page 14 when nished
making changes.
Trigger
Pulls
Rate of
Fire (bps)
Dwell
(msecs)
1 0.5
2 1
3 1.5
4 2 2
5 2.5 2.5
6 3 3
7 3.5 3.5
8 4 4
9 4.5 4.5
10 5 5
11 5.5 5.5
12 6 6
13 6.5 6.5
14 7 7
15 7.5 7.5
16 8 8
17 8.5 8.5
18 9 9
19 9.5 9.5
20 10 10
21 10.5
22 11
23 11.5
24 12
25 12.5
26 13
27 13.5
28 14
29 14.5
30 15
Table 1: Rate of Fire and Dwell Settings