User Manual

3
direction will purge air from the marker. If you wish, you can leave the cylinder attached for
the next paintball event. See unloading instructions in your Crossover Owner’s Manual for
additional information.
To disassemble the Regulator, remove the cylinder from the ASA threads. Once the cylinder
is removed, further clockwise rotation of the knurled
surface will allow disassembly of the purge assembly.
WARNING
Whenever performing maintenance,
disassembling, or cleaning your
marker, always fully remove the air
cylinder. See your Crossover Owner’s
Manual for detailed instructions.
17
9
8
3
1
15
14
10
18
21
19
2
4
6
5
7
11
16
12
13
22
Venting Regulator Assembly
20
OFF / Purge /
Disassemble
ON / Pressurize
Item Qty Part No. Description
1 1 TA35067 Regulator Adjustment Cap
2 1 TA35050 Regulator Piston Guide
3 1 TA30031 Spring
4 1 TA30048 Regulator Spring Wear Disk
5 1 TA35091 Regulator Piston
6 1 TA35055 O-Ring, CU, 70A, 2-013
7 1 TA35087 O-Ring, CU, 90A, 2-004
8 1 TA35144 Venting Regulator Body
9 1 TA20075 Regulator Pin Seat
10 1 TA35092 Regulator Poppet
11 1 02-88 Spring
Item Qty Part No. Description
12 1 TA35136 Poppet Housing
13 1 TA35132 Valve Housing
14 1 TA20041 O-Ring, CU, 70A, 2-014
15 1 18-PA Cylinder O-Ring
16 1 TA30049 O-Ring, 2-008
17 1 TA35134 Exhaust Pin
18 1 TA35131 Threaded Pin Guide
19 1 TA35135 Dowel Pin
20 1 TA35137 Glide Ring
21 1 TA35133 Valve Knob
22 1 TA35147 O-Ring, CU, 90A, 2-020