User Manual

Getting Started

• Eyeprotectiondesignedforpaintballusemustbewornbytheuserandanyperson

withinrange.

• Donotdisassemblethismarkerwhileitispressurized.

• Donotpressurizeapartiallyassembledmarker.

• Readeachstepcompletelybeforeperformingthestep.

NOTE:Carefullyhandstartallthreadedpartswhenassembling,anddonotovertighten,as

thismaypotentiallystripthethreadedparts.RefertotheParts Diagramonpages18and19

fortheseinstructions(itemnumbersarecircledandinparentheses).

WARNING

Install the air supply and load the hopper with paintballs only after you:

• have a Barrel Blocking Device installed (see page 4)

• have the Trigger Safety in Safe mode (see page 6).

Eye protection designed for paintball use must be worn by the user

and any person within range.

1. Install the Barrel

a. MakesuretheBarrelO-Ring(36,seearrowatright)isin

placeinsidetheBarrelAdapter(35).

b. TurntheBarrelclockwiseintotheAdapter,untiltight.

2. Customize the Cronus

OptionalCollapsibleStock:

a. IfyourCronuscame

withacollapsiblestock,ndthe10-32x1/2”black

screw(49)intheMaintenancePack.

b. RemovetheEndCapCover(A).

c. InserttheStockintotheslotsontheEndCapof

themarker(B).

d. Insertandtightenthescrew(C).

Length Adjustment

1. SqueezetheAdjustmentLever.

2. SlidetheStocktoachievethedesiredlength.

3. ReleasetheAdjustmentLevertolockitinto

place.

BarreL adapter