User Manual

WARNING

Always keep the Barrel Blocking Device installed except

when your marker is in use. Always make sure that the

Trigger Safety is in the Safe mode (see instructions

on page 6) and the Barrel Blocking Device is properly

installed on your marker according to the instructions to

prevent damage to property, serious injury, or death.

Barrel Blocking Device Installation Instructions

1. Fully collapse the adjustable stock. See page 8 for instructions.

2. Place the Barrel Blocking

Device onto the Barrel,

loop the cord over the top

of the receiver, behind

the collapsible stock, and

position at the back of the

grip as shown.

3. Adjust the cord length

retainer up to the back of the grip by pulling the cord through

it until the retainer is snug against the back of the grip.

Keeping the cord as tight as possible, leave just enough

cord elasticity to pull the cord/retainer up over the top of the

marker to remove the Barrel Blocking Device for ring.

4. After the cord length is properly adjusted, lock the cord

length by tying a knot in the cord against the back of the

retainer as shown.

5. Before and after playing, inspect the Barrel Blocking Device. Replace the Barrel

Blocking Device if the device or cord is damaged, or there is a loss of cord elasticity.

6. Clean the Barrel Blocking Device with plain, warm water and store out of sunlight in a

dry area when not in use.

WARNING

This is not a toy. Misuse may cause serious injury or

death. Eye, face, and ear protection designed for paintball

must be worn by the user and any person within range.

We recommend you be at least 18 years old to purchase.

Persons under 18 must have adult supervision when

using this product. Read the Owner’s Manual before using

this product.

Cord Length retainer

BarreL BLoCking

deviCe