User Manual
16
E
N
G
L
I
S
H
Reassembling Receiver Halves
1. Refer to the diagram below and the diagram at the bottom of page 14. Double check
that the following parts are in place:
Barrel Adapter (35, oriented as shown), Trigger (42), and Pins (63), Trigger Spring (50),
Safety (54), Sear Pin (57), Sear (64), Sear Spring (50), Front Bolt* (33), Ball Latch (52),
Linkage Arm* (11), Rear Bolt* (20), Drive Spring* (17), Guide Pin* (18), Bumper O-ring
(16), and End Cap (15).
(* = indicates to be lubricated with Tippmann Certied Marker Oil).
2. Carefully install the left receiver half (make sure halves t ush).
3. Install four long receiver screws (51). Install six short receiver screws (49). Install the
self-tapping grip screw (48) into the right receiver half.
4. If applicable, reinstall the Silencer Assembly to the Barrel Adapter.
5. Insert the Barrel (37) and carefully screw it into the Barrel Adapter.
33
31
Reassemble Internal Components
35
52
11
16
17
15
66
20
42
63
50
63
50
54