User Manual

ManualsBrandsTippmann ManualsPaintballCronus

pull the trigger and allow the Rear Bolt Handle to move slowly forward (arrow B) which

uncocks the marker.

3. If applicable, remove the Silencer Tube (72) by turning it 1/8 turn counter clockwise

and removing from the Barrel Adapter (35).

4. To remove the Barrel (37), turn the Barrel counterclockwise from the Barrel Adapter.

Prior to reassembly, make sure the O-Ring (36) inside the Barrel

Adapter is lubricated with Tippmann Certied Marker Oil. Turn the

Barrel clockwise to thread it into the Barrel Adapter.

5. To remove the Foregrip (68), loosen the hex screw (67) from the

hex nut (70). The Foregrip parts separate to remove it.

6. Remove the Carry Handle Assembly by turning the two Clamp

Nuts

(82) counter-clockwise until the clamp is totally loose (see

page 9). When loose, remove the screws and remove the Carry Handle.

7. Turn the Velocity Screw (32) all the way in until it stops.

8. Remove the screw (49) holding the Collapsible Stock to the End Cap (15), as shown

on page 8. Pull down on

the stock to remove it from

the End Cap.

9. To remove the left-side

Receiver (2), unscrew

six short receiver screws

(49) and four long receiver

screws (51). On the right

side of the grip, remove

the self tapping screw (48).

Then carefully lift the left-

side receiver to access the

internal parts.

10. With left half removed,

lift the End Cap (15) out to remove the Bumper O-Ring (16), Guide Pin (18) and

Drive Spring (17). These parts must be removed before the Rear Bolt Handle (66)

can be removed from the Rear Bolt.

11. Disconnect the Linkage Arm (11) from the Rear Bolt (20) and Front Bolt (33).

12. Slide the Front Bolt off the Power Tube (31) and check the O-Ring (34). Clean and oil

the O-Ring or if damaged,

replace with a new one.

Do the same with the Rear

Bolt O-Ring (21).

13. To disassemble the

Trigger (42), rst remove

the Trigger Linkage

Arm

(62). The Trigger

can be removed from

the marker, but be sure

to capture the Trigger

Spring

(50) when

removing the Trigger. The

Trigger Adapter (58)

assembly can be removed

from the pins (63) if

desired.

Remove Screws From Left Receiver Half