Back Cover Blank TIPPMANN TM C3 TM Owner’s Manual Le Manuel du Propriétaire Manual del Usuario PN# TP04700 Date: 9/05
TIPPMANN TM WARNING E N G L I S H THIS IS NOT A TOY. MISUSE MAY CAUSE SERIOUS INJURY OR DEATH. EYE, FACE AND EAR PROTECTION DESIGNED FOR PAINTBALL MUST BE WORN BY THE USER AND ANY PERSON WITHIN RANGE. WE RECOMMEND AT LEAST 18 YEARS OLD TO PURCHASE. PERSONS UNDER 18 MUST HAVE ADULT SUPERVISION WHEN USING THIS PRODUCT. READ THE OWNER’S MANUAL BEFORE USING THIS PRODUCT. WARNING BARREL SLEEVE INSTALLATION 2955 Adams Center Road, Fort Wayne, IN 46803 USA P) 260-749-6022 • F) 260-749-6619 www.tippmann.
Safety Is Your Responsibility (continued from page 4) Warning/Liability Statement E N G L I S H This marker is classified as a dangerous weapon and is surrendered by Tippmann Sports, LLC with the understanding that the purchaser assumes all liability resulting from unsafe handling or any action that constitutes a violation of any applicable laws or regulations.
Safety Is Your Responsibility (continued from page 5) E N G L I S H Safety Is Your Responsibility (continued from page 6) • Before storing or disassembling: 1) Remove paintballs from the marker. Completely empty the hopper, point your marker in a safe direction, fire several times to be sure there are no balls lodged in the chamber and/or barrel. 2) Remove the propane supply then pump and fire in a safe direction until there is no propane left in the marker.
Priming The Marker (continued from page 8) GETTING STARTED DANGER not proceed until you have E Do both familiarized yourself with Y FLAMMABLE • EXTREMEL EXTREMELY and are prepared to always N follow guidelines for proper • FIRE/EXPLOSION HAZARD • CONTENTS UNDER PRESSURE cylinder and marker G propane • CARBON MONOXIDE HAZZARD handling and storage. L STEP 1: Installing / Replacing the Battery I This marker needs a good battery to operate.
C3TM Parts List WARNING E N G L I S H DO NOT DISASSEMBLE THIS MARKER WHILE IT IS PRESSURIZED WITH PROPANE. DO NOT PRESSURIZE A PARTIALLY ASSEMBLED MARKER. TIPPMANN 1-800-533-4831 www.tippmann.
Cleaning and Maintenance (continued from page 12) Unloading Your Marker E N G L I S H Before storing or disassembling be sure to remove paintballs and propane supply. • To unload your marker: remove or completely empty the hopper. Then, point your marker in a safe direction and fire several times to be sure there are no balls lodged in the chamber and / or barrel. • Propane Supply Cylinder Removal: To remove a propane supply cylinder, turn the cylinder counterclockwise or out.
Rear Valve / Piston Cleaning (continued from page 13) WARNING E FIRING YOUR MARKER WITHOUT THE VELOCITY SCREW INSTALLED CAN THE PISTON TO BE EJECTED FROM THE REAR OF THE MARKER. N h)CAUSE Carefully screw the Velocity Screw into the Rear Valve G until at least flush with the end of the Rear Valve body and L then replace the End Cap. Cleaning is complete. You will need to adjust velocity as outlined on page 9.
Receiver Disassembly (continued from page 15) E N G L I S H 5) Battery Removal: Remove the 2 Left Grip screws , the Left Grip and pull up loose end of ribbon under the Battery to pop it out. 6) Pull the end cap out of the receiver. 7) Remove the Regulator - 2 bolts at . 8) Remove the Regulator Adapter - 2 bolts at . 9) Remove the 2 Banjo Fittings and Gas Hose as 1 piece from the right side of the marker. Clean and inspect the o-ring on each Banjo Fitting for wear and oil (replace if necessary).
Chamber Disassembly (continued from page 17) E N G L I S H • With Piston o-rings lubricated, insert piston into the Rear Valve (closed end of piston goes in first). • Insert the spring, buffer o-ring and carefully screw the Velocity Adjustment Screw in until flush with end of the Rear Valve body. 17) Pull the Forearm Grip/Front Valve/Exhaust Valve Assembly from the Chamber. • Clean the back face of the Front Valve Body with WD-40 and wipe clean.
TROUBLESHOOTING TippmannTM C3TM - Frequently Asked Questions If your marker will not fire: • Check to be sure the safety is in the FIRE position. See safety instructions on page 4. • Check to be sure your propane tank is not empty. • Battery may be bad. See battery replacement on page 8. • The Spark Plug may be dirty and need to be cleaned. See Spark Plug Cleaning and Maintenance on page 13. • Fuel Air Mixture may need adjustment. See Regulator Adjustment on page 14.
Frequently Asked Questions (continued from page 21) your local dealer or TippmannTM Service and we can fix your marker. Assuming there is no issue with the propane tank, the leak is handled the same way as a standard C02 leak. 9. When using the marker I noticed the marker felt warm. Is this normal? It is normal for the marker to become very warm when shooting. 10.
E-mail Phone # State Country # Zip Age Zip Date Male Female Warranty Registration online at www.tippmann.com or complete this warranty card and mail to TippmannTM. State TM TM City Address Your Name (print) Country City Purchased from Serial Number: C3 2955 ADAMS CENTER ROAD FT.
E-mail Pays País Ville Ciudad Addresse Dirección TM Votre nom Nombre (letra de molde) Pays País Ville Ciudad Acheté du Nombre comprador Numéro Sérial: Número de Serie: C3 2955 ADAMS CENTER ROAD FT. WAYNE, IN 46803 USA TM TIPPMANN Inside Back Cover Blank L’Insription de Garantie sur l’internet à www.tippmann.com ou complétez la carte de d’inscription et l’envoyez à TippmannTM.
