User's Manual

❏
Clockwise
to slow the
rate of fire.
Tuning The Response
TM
Trigger Rate of Fire
❏ Eye protection designed for paintball use must be worn by the user and
any person within range.
Tuning - Troubleshooting B:
If the trigger remains easy to pull after adjusting the flow control, there
may be a leak in the system.
Tuning - Troubleshooting A:
If tuning the Response
TM
trigger, above, produces little or no response
in the rate of fire, reset the Flow Control as follows:
1) With marker properly unloaded (see page 18), begin adjusting rate
of fire by turning flow control clockwise
completely. Do not over tighten
or damage will occur. In a safe direction fire 2 to 4 shots. Trigger
should become very hard to pull or even unable to be pulled. If this
occurs, the response trigger system is functioning properly. Go to step
2). If it does not occur, go to Troubleshooting B.
2) Now while firing in a safe direction with marker still unloaded, slowly
turn the flow control adjustor counterclockwise
until desired rate of
fire is achieved.
MODEL SPECIFICATIONS
Model Basic........................................................ TIPPMANN
®
A-5
TM
Caliber ............................................................................................ .68
Action ................................. Semi-Automatic (open bolt blow-back)
Power/Air Supply........... compressed air, nitrogen or CO2 cylinder
Hopper Capacity......................................................... 200 Paintballs
Ball Feed ........................................ TIPPMANN
®
Cyclone
TM
System
Standard Barrel Length ............................................. 8.5” /21.59 cm
Length (with standard barrel & no tank) .................... 20” / 50.8 cm
Effective Range ...................................... 150+ feet / 45.72+ meters
Cycle Rate ..................................................... 8 Rounds Per Second
Weight (without tank) .......................................... 3.12 lbs / 1.415 kg
Velocity ................. Always measure your marker’s velocity before
playing paintball and never shoot at velocities in excess of 300
feet / 91.44 meters per second (see instructions on page 7).
Model Specific ...................... TIPPMANN
®
A-5
TM
WITH E-GRIP
TM
Cycle Rate .......................... adjustable8-15Rounds Per Second
Battery ........................................................................................ 9 Volt
Weight (without tank) ............................................ 3.27 lbs / 1.48 kg
Model Specific ......................... TIPPMANN
®
A-5
TM
RESPONSE
TM
Cycle Rate ................................................... 15 Rounds Per Second
Weight (without tank) ............................................ 3.16 lbs / 1.43 kg
Model Specific ............................. TIPPMANN
®
A-5
TM
STEALTH
TM
Flatline Barrel Length .............................................. 8.75” / 22.23cm
Length (no tank) ................. 27.25” - 30.75” / 69.21 cm - 78.1 cm
Weight (without tank) ................................................. 5 lbs / 2.27 kg
Cycle Rate ...................................................... 8 Rounds per second
Effective Range ............................................... 250+ ft / 76.2 meters
E
N
G
L
I
S
H
E
N
G
L
I
S
H
14 15
H-01
Remote Coil
T201012
FLATLINE
TM
02-TAC
Collapsible Stock
Model SpecificParts: A-5
TM
STEALTH
TM
Not Shown on A-5
TM
Basic Parts List pages 16-17.
(replaces standard
Barrel & Barrel
Adaptor)
(replaces
standard End
Cap assembly)
(replaces
standard
Gas Line
and Tank
Adaptor)
98-40
O-ring
A-5
TM
RESPONSE
TM
Model Specific Parts: Not Shown on
A-5
TM
Basic Parts List pages 16-17.
❏ Counterclockwise to increase
rate of fire to the
desired speed.
Double check installation
making sure all fittings are
tight and o-rings are
properly seated. If you
need to disassemble to
check that all fittings are
tight and o-rings are
properly seated, follow the
Marker / Receiver
Disassembly instructions
beginning on page 21.
Do NOT disassemble the
marker while it is pressurized
with air.
If a problem still exists,
call the Tippmann
Service Department at
1-800-533-4831.
With a screwdriver, turn the Flow Control Adjustor to the desired speed.