Manual

counterclockwise to increase
rate of fire to the
desired speed.
clockwise
to slow the
rate of fire
Tuning The Response
TM
Trigger Rate of Fire
With a screwdriver, adjust the Flow Control Valve
Tuning - Troubleshooting B:
If the trigger remains easy to pull after adjusting the flow control,
there may be a leak in the system. Double check installation
making sure all fittings are tight and o-rings are properly seated.
If you need to disassemble to check that all fittings are tight
and o-rings are properly seated, follow Receiver
Disassembly instructions beginning on page 17. Do NOT
disassemble this marker while it is pressurized with air.
If a problem still exists, call Tippmann Service Department at
1-800-533-4831.
Tuning - Troubleshooting A:
If tuning the Response
TM
trigger, above, produces little or no
response in the rate of fire, reset the Flow Control as follows:
1) With marker properly unloaded (see page 16), begin
adjusting rate of fire by turning flow control clockwise
completely. Do not over tighten or damage will occur. In a
safe direction fire 2 to 4 shots. Trigger should become very
hard to pull or even unable to be pulled. If this occurs, the
response trigger system is functioning properly. Go to step 2.
If it does not occur, go to Troubleshooting B.
2) Now while firing in a safe direction with marker still unloaded,
slowly turn the flow control adjustor counterclockwise until
desired rate of fire is achieved.
A-5
TM
Response
TM
and A-5
TM
Stealth CR-15
TM
Markers:
Response Parts Not Shown on A-5
TM
Parts List pages 14/15
Model Specifications
Model Basic .......................................... TIPPMANN
TM
A-5
TM
Caliber.............................................................................. .68
Action ....................... Semi-Automatic (open bolt blow-back)
Power/Air Supply.. compressed air, nitrogen or CO2 cylinder
Hopper Capacity ................................................ 200 Rounds
Standard Barrel Length ................................................... 8.5”
Length (with standard barrel & no tank) ........................... 20”
Effective Range ...................................................... 150+ feet
Cycle Rate ......................................... 8 Rounds Per Second
Weight (without tank) ............................................... 3.12 lbs.
Velocity ....... Always measure your marker’s velocity before
playing paintball and never shoot at velocities in excess
of 300 feet per second (see instructions on page 7).
Model Specific ............TIPPMANN
TM
A-5
TM
WITH E-GRIP
TM
Cycle Rate ....................................... 17 Rounds Per Second
Weight (without tank) ............................................... 3.27 lbs.
Model Specific .............. TIPPMANN
TM
A-5
TM
RESPONSE
TM
Cycle Rate ....................................... 15 Rounds Per Second
Weight (without tank) ............................................... 3.16 lbs.
Model Specific ...................... TIPPMANN
TM
A-5
TM
Stealth
TM
Flatline Barrel Length .................................................... 8.75”
Length with collapsible stock extended ......................... 27.25”
Weight (without tank) .................................................... 5 lbs.
Cycle Rate .......................................... 8 Rounds per second
Effective Range ......................................................... 250+ ft.
Model Specific ........................TIPPMANN
TM
A-5
TM
CR-15
TM
Flatline Barrel Length ..................................................... 8.75”
Length with collapsible stock extended (without tank) ..... 27.25”
Weight (without tank) .................................................... 5 lbs.
Cycle Rate ........................................ 15 Rounds per second
Effective Range ......................................................... 250+ ft.
E
N
G
L
I
S
H
E
N
G
L
I
S
H
12 13
A-5
TM
Stealth
TM
H-01
Remote Coil
T201012 FLATLINE
TM
02-TAC
Collapsible Stock
A-5
TM
Stealth
TM
and A-5
TM
Stealth CR-15
TM
Model Specific Parts Not Shown on A-5
TM
Schematic Pages
(replaces standard
Barrel & Barrel
Adaptor)
(replaces standard End
Cap assembly)
(replaces
standard
Gas Line
and Tank
Adaptor)
98-40
O-ring
(02-86
replaces
receiver
Banjo Fitting)
(02-83
Replaces
Short
Receiver Bolt)
(02-85
replaces
receiver nut)