Manual

E-GRIP
TM
Tuning and Operating Instructions
Familiarize yourself with and follow these instructions to select
the firing mode of your choice from the Firing Mode Setting -
Firing Response Description options.
TURNING ON = The E-GRIP
TM
automatically turns on when
you pull the trigger.
TURNING OFF = The E-GRIP
TM
automatically turns off after
10 minutes or so of inactivity.
Firing Mode Setting... Firing Response Description:
0 =NO OPERATION .... No response.
1 =SEMI AUTO............ Fires one shot for each pull of the
trigger.
2 =NO OPERATION .... No response.
3 =AUTO RESPONSE Fires one shot for each pull or
release of the trigger. If the trigger is held for an extended
period, when the trigger is released no shot is fired.
4 =NO OPERATION .... No response.
5 =FULL AUTO............ Fires shots repeatedly as long as the
trigger is held.
6 =NO OPERATION .... No response.
7 =3 SHOT .................. Fires either a 3 shot burst when the
trigger is held or if trigger is released before 3 shot cycle
is complete - firing stops at that point of cycle.
8 =NO OPERATION .... No response.
9 =TURBO .................. Fires one shot for each pull of the
trigger until the time between trigger pulls is below .25
seconds - it then goes to one shot for each pull or release
of the trigger.
Selecting Firing Mode
Mode Adjustment - Top Access Opening
•With screwdriver, turn the Mode Adjustment
switch to select desired firing mode setting.
Selecting Rate of Fire
Rate Adjustment - Lower Access Opening
•Turn the Rate of Fire
Switch clockwise
to increase the
rate of fire.
• Turn the Rate
of Fire Switch
counterclockwise
to slow the rate of fire.
E-GRIP
TM
-Troubleshooting
Problem: If you pull the trigger and marker does not fire.
1) Check to be sure safety is off.
2) Make sure sufficient air supply is hooked up to marker.
3) Firing Mode may be set to “= NO OPERATION”.
With screw driver, turn Mode adjustment, access through top
hole in lower receiver, 1 position (click) try trigger again.
4) Battery may be disconnected - Check battery clip connection.
5) Battery may be bad - replace battery (see page 8).
6) Internal wire may be disconnected.
Inspect wire connections inside lower receiver. Do NOT
disassemble this marker while it is pressurized with air. Remove
lower receiver as outlined in Receiver Disassembly on page
17. Remove left grip half, 3 screws & tank adapter bolt, and
visually inspect internal wire connection points for dis-
connected wire end. When replacing grip half, be sure wires
are positioned in slot and cutout area so wires are not pinched
or sheared. If a problem still exists, call: Tippmann
TM
Service
Department at 800-533-4831.
Trigger
Switch
Wire Connection
points
INTERNAL
PARTS:
E-GRIP
TM
Lower
Right
Receiver
Half
Battery wires in slot
Cutout
area to
position
wires for
capacitor &
solenoid
Battery Clip Connector
Armature Pin
Armature
Computer Board
Capacitor
Mode Switch / access
Rate of Fire Switch / access
Solenoid
x
E
N
G
L
I
S
H
E
N
G
L
I
S
H
10 11
A-5
TM
E-GRIP
TM
Parts Not Shown
on A-5
TM
Parts List Page 14.
02-02LE
Lower
Receiver
Left
02-02RE Lower
Receiver
Right
02-91
Armature Pin
02-90
Sear Tripper
TA01135 Sear
02-88
Sear
Spring