Manual

Purchased from Date
Serial Number (Number above left front grip).
Your Name (print)
Phone #
Country
Address
Country
2955 ADAMS CENTER ROAD
FT. WAYNE, IN 46803 USA
Male
Age
Female
TIPPMANN
TM
Email
#
City State Zip
City State Zip
Warranty Registration online at www.tippmann.com or complete this warranty card and mail to Tippmann.
Check Model: ❏ A-5
TM
❏ A-5
TM
WITH E-GRIP
TM
❏ A-5
TM
RESPONSE
TM
❏ A-5
TM
STEALTH
TM
❏ A-5
TM
STEALTH CR-15
TM
E
N
G
L
I
S
H
22
Repairing Air Supply Cylinder Leaks
The most common leak occurs from a bad air supply
valve o-ring. To replace a valve o-ring you must first remove
the bad o-ring and then install a new one. This o-ring is
located on the tip of your air supply valve. The best valve o-
rings are made of urethane. The urethane o-rings are not
affected by high air supply pressures. These may be
purchased from Tippmann
TM
or your local paintball dealer.
NOTE: If new valve o-ring does not resolve air supply leak,
do not attempt to repair air supply cylinder. Contact Tippmann
Sports, LLC or your local paintball dealer.
Storage
Before storage unload and remove air supply (see page 16).
Then install Barrel Sleeve (see page 2) and put your marker
in Safe Mode (see page 4). You should store your marker in
a dry area. Before storing your marker make sure that the
marker is cleaned and oiled (see cleaning and maintenance
on page 16) so that it does not rust. Store your marker with
the bolt in the forward position, uncocked.
When removing your marker out of storage make sure Barrel
Sleeve is installed (see page 2) and safety is in Safe Mode
(see page 4). You should re-oil the rear bolt and the front
bolt o-ring before use.
Collapsible Stock Length Adjustment
Squeeze the
adjustment lever
and slide to shorten
or lengthen stock.
Shorten