Owner's Manual

8
E
N
G
L
I
S
H
Getting Started
• Eyeprotectiondesignedforpaintballusemustbewornbytheuserandanyperson
withinrange.
• Donotdisassemblethismarkerwhileitispressurizedwithair.
• Donotpressurizeapartiallyassembledmarker.
• Readeachstepcompletelybeforeperformingthestep.
NOTE:Carefullyhandstartallthreadedpartswhenassembling,anddonot
overtighten,asthismaypotentiallystripthethreadedparts.
1. Air Supply Cylinder Installation.
ReviewAir Supply Cylinder RemovalandSafety Tips(seepage10).Donotpressurizea
partiallyassembledpaintballmarker.
a. PuttheTriggerSafetyinSafemode(seepage6)andinstalltheBarrelBlocking
Device(seepage4).
b. AsshowninFigure2,cockthemarkerbypullingthebolt
handleallthewaybackuntilitlocksintoplace.Always
keepmarkerinthecockedpositionwhentheairsupplyis
attachedtothemarker.Thishelpspreventanaccidental
discharge.
c. LubricatethecylindervalveO-RingwithTippmann
®

CertiedMarkerOil,ifneeded.
d. Inserttheairsupplycylindervalveintotheairsupply
adapter(ASA)atthebackendofthemarkergrip.
e. Twistthecylinderclockwiseintotheairsupplyadapteruntilitstops.Usecautionas
themarkerisnowcapableofringafteryouputtheTriggerSafetyinFiremode.If
thetankisfull,andyoudonotheartheairsupplyengage,thepinvalvecouldbetoo
shortorthepinvalvesealisdamaged(followtheAir Supply Cylinder Removal
instructionsonpage10,andtakeyourairsupplycylindertoa“C5”CertiedAirsmith
forinspectionorcontactthecylindermanufacturer).
2. Loading the Hopper
TheBarrelBlockingDevicemustbeinstalled(seepage4)andtheTriggerSafetymustbein
Safemode(seepage6).
a. MakesurethattheFeedElbowandHopperarecleanandfreeofsharpedgesor
debris.Thiskeepspaintballsfrombreakingprematurely,andallowspaintballsto
feedtothemarker’schambersmoothly.
b. InstalltheHopperneckintotheFeedElbow.
c. TightentheFeedElbowBoltusingtheincluded3/16”allenwrench.Donotover-
tighten,astheFeedElbowmaybreak.
d. VerifythattheBarrelBlockingDeviceisinstalled(page4),andtheTriggerSafetyin
Safemode(page6).
e. Loadyourhopperwith.68caliberpaintballs.Donotattempttoforcemorepaintballs
intothehopperthanwhatitwillhold.Afterllingthehopper,onlyremovethebarrel
blockingdeviceandmovethesafetytoFiremodewhenyouarereadytoshoot.
Figure 2:
Cocking the Marker