Owner's Manual

4
E
N
G
L
I
S
H
WARNING
Always keep the barrel blocking device installed except when
your marker is in use. Always make sure that the trigger safety
is in the safe mode (see instructions on page 6) and the barrel
blocking device is properly installed on your marker according
to the instructions to prevent damage to property, serious injury,
or death.
Barrel Blocking Device Installation Instructions
1. Place the Barrel Blocking Device onto the Barrel,
loop the cord over the top of the receiver, and
position at the back of the grip as shown.
2. Adjust the cord length retainer up to the back of the
grip by pulling the cord through it until the retainer is
snug against the back of the grip. Keeping the cord
as tight as possible, leave just enough cord elasticity
to pull the cord/retainer up over the top of the marker
to remove the Barrel Blocking Device for ring.
3. After the cord length is properly adjusted, lock the
cord length by tying a knot in the cord against the
back of the retainer as shown.
4. Before and after playing, inspect the Barrel Blocking Device.
Replace the Barrel Blocking Device if the device or cord is
damaged, or there is a loss of cord elasticity.
5. Clean the Barrel Blocking Device with plain, warm water and store out of sunlight in a
dry area when not in use.
Cord Length
Retainer
WARNING
This is not a toy. Misuse may cause serious injury or death. Eye,
face, and ear protection designed for paintball must be worn by
the user and any person within range. We recommend you be
at least 18 years old to purchase. Persons under 18 must have
adult supervision when using this product. Read the Owners
Manual before using this product.
Barrel Blocking Device